艾美特空調扇使用方法
1、擺動送風
一般的空調扇都具有左右擺動送風功能，當需要擺動送風時，只需要按“風向”選擇鍵一次，使“擺動風”指示燈亮，即馬上自動左右送風，送風角度120度，若不需要擺動送風，再按風向選擇鍵一次，使“定向風”指示燈亮，則停止擺動定向送風。同時還可調整上下送風位置，如用手調整導風片的方向，可使送風方向全部向下或向上，根據你的需要調整到最理想的位置。
該圖片由注冊用戶"品牌知識"提供，版權聲明反饋
2、適當加濕
若要用制冷加濕送風作用，首先必須在水箱中加注清水，開機工作約1-3分鐘后，出風溫度由環境溫度降低并達到效果。有條件時加注低溫冷水或冰水，降溫效果更佳。若在水中加入適量香料，吹出來的將是一陣陣馨香清涼的和風，在炎熱的夏季，使人心曠神怡，備感愜意。輕按制冷加濕，指示燈亮，啟動加濕功能，如取消加濕功能再輕按此鍵，指示燈滅，加濕功能停止。
3、冷凍冰晶
一般的空調扇都配有兩個冰晶，每天晚上，把其中一個放在家里的冰箱冷藏柜里冷藏一段時間，第二天拿出來放到水箱里用，效果更好。
艾美特空調扇怎么加水
空調扇應放置水平，注意使用時不得傾斜，使用前檢查插座電源是否與風扇銘牌上的參數一致。新機或長時間停用后的空調扇，必須在使用前灌注清水，可通過水標觀察水位情況，控制加水量，加水前應拔下電源插頭，以防止電器元件受損，待灌的水位上升到接近“”位置即可，不要過滿；灌好水后，把扇門關上，在作制冷使用時，要注意觀察水標的情況，當水位下降到接近“”位置時，即應補充加水，否則將會失去制冷效果。
