一、人行通道閘機的安裝方法
人行通道閘機是通道出入口處安裝的門禁設備，用于管理、控制人員進出，在寫字樓、小區、地鐵站等場所很常見，人行通道閘的安裝方法是：1、開槽布線：通道閘機主機到電源和交換機之間需要連接電源線與網線，主機與副機之間需要連接同步線和讀頭線，線需穿入PVC管并埋于地下。2、閘機固定：機箱通過壓塊和膨脹螺釘固定于地面上，需要在地面鉆孔并打入膨脹螺釘。3、接線安裝：需要接線的設備包括：閘機主機和輔機通過自帶的同步線連接、門禁控制器與RFID讀頭連接、門禁控制器與閘機輔機連接、閘機主機外接電源線、門禁控制器與信息主機通過網線分別連接到交換機。按照安裝說明書上的接線圖進行接線即可。
二、通道閘機故障大全
1、通道閘刷卡后，有一邊閘機開，另一邊閘機不開：（1）重新檢查同步上線是否連接正確，確保連接正確后，檢查未開閘的閘門的控制主板是否收到開閘信號。如果沒有，請重新檢查布線是否脫落，主板上的插頭是否正確插入。（2）控制主板的端子有問題，建議更換。2、斷電之后，閘機不自動敞開：（1）檢查電池是否充電，用萬用表檢查是否在10V以上。否則，充電。如果無法充電，請更換電池。（2）檢查控制主板是否有問題，如果有，請更換。3、閘機開閘，但閘門不關：（1）檢查左右門的紅外光電傳感器是否對準。模擬走過通道，看看控制主板上紅外光電傳感器的工作燈是否正常，否則就證明紅外光電傳感器壞了，需要更換。（2）確保控制主板沒有問題，如有問題，更換。4、通道閘機刷卡或驗票后，不能進入：（1）行人在刷卡或驗票時頂住了轉桿，請游客向后退一步再進入即可。（2）檢查電磁鐵是否正常。如果控制部分有電磁鐵的電壓有輸出，且電壓正常，但電磁鐵卻不能吸起，則更換電磁鐵即可。5、通道閘機的轉盤上下擺動：（1）機芯轉盤的托盤松動，配合之間間隙過大，調緊托盤。（2）托盤螺絲松動，擰緊螺絲。6、閘機過人掉桿：（1）落桿電磁鐵的位置沒有裝好，重新安裝。（2）電源問題，電壓不夠，調整電壓。7、打卡閘機有時不能順利抽卡：帶打卡功能閘機插票處的2塊鐵片還需打磨光滑，以減少插票阻力。
三、人臉識別通道閘機系統多少錢一臺
人臉識別通道閘機是采用先進的生物特征識別技術和現代電子技術相結合的一種新型通道控制設備，在保障人員快速通過的同時大大提高了工作效率，應用廣泛。作為人臉識別系統的一部分，人臉識別通道閘機系統的價格主要受到閘機材質、尺寸、款式、生產廠家等諸多因素的影響，一般價位大概在2000元-10000元一臺左右。購買時，要注意看外觀、看材質、摸質感、測性能、查服務等幾個選購要點，如果您需要購買人臉識別通道閘機的話，可以先來了解一下通道閘十大品牌。
四、閘機系統通道閘的優勢
1、輕柔無聲，雖然速度快，但通道閘能做到靜音，開關閘門動作輕柔無聲，無機械摩擦，不會影響到其他人工作和心情。2、通道閘正常通行，會有語音、燈光提示，給人一種親切感。3、通道閘從外觀上看比較美觀時尚，顯得大氣上檔次。4、通道閘開閘速度很快，0.3-0.8秒/次，通行30-45人/分鐘，可以連續刷卡，連續開閘，通道閘有記憶功能，可以降低通行時間，提高通行效率。5、通道閘具有防撞、自動復位、遇阻返回等功能，安全性強。
