1、手機型號是否支持無線充電OR無線充電器是否匹配

無線充電器有時候放上去沒反應，首先要看手機型號支不支持，需不需要外加裝無線充電線圈。

a.手機內置無線充電接收端：直接放在無線充電器上就可以充電。

b.手機內部預留了無線充電接收端觸點：需要加裝無線充電接收線圈實現無線充電的。

c.手機本身完全不支持無線充電，需要加裝一個無線充電接收背架的實現無線充電的。

2、無線充電器指示燈是否顯示正常

其次，有些品牌的無線充電器周圍有LED燈，當手機放在無線充電器上充電時，無線充電器周圍的LED燈會亮起，或者有的是提示音，顯示使用狀態。也有的時候是反應遲鈍，放上去需要等幾秒才充電，有時還得重放。

3、手機保護殼等無線充電器外在影響因素

然后，請檢查手機是否是背面中心置于無線充電板中心處，查看手機與無線充電板之間有夾雜物時，可能無法正常充電；再檢查檢查手機后殼，若使用的保護性手機套太厚可能會阻礙無線充電，建議拆掉手機套重新充電嘗試。

4、無線充電器正常工作需要滿足的條件

最后，無線充電器的發射器功率，可能也會導致無線充電用不了的原因。接收器輸出的短路電流能達到1A，實際在充電時只有0.3左右了，插上手機電壓直接降到3.9V了，這個電壓根本達不到給手機充電的額定電壓，而且無線發射器的最大工作電流才600ma，智能手機充電需要700ma~800ma以上，所以無線充電器的發射功率過小，也會使得充電充不進去。